[Back]


Diploma and Master Theses (authored and supervised):

W. Lehner:
"Evaluation of Environmental Stresses on GNSS-Monuments";
Supervisor: S. Bergstrand, R. Haas, A. Wieser; E128-3, 2011; final examination: 2011-11-21.



English abstract:
The aim of this thesis is to analyze four di erent constructions of GNSS-antenna monuments
with respect to deformations due to solar radiation, temperature variations
and wind. It was commissioned by Lantmäteriet, the Swedish mapping, cadastral and
land registration authority and realized in cooperation between Vienna University of
Technology and Chalmers University of Technology. In the rst part of the project a
simulation with a nite element modelling program was calculated. The values gained
from the simulations reached a maximum of 1.4mm due to wind, 1.2mm due to solar
radiation and 0.8mm due to thermal expansion. In the second part outdoor measurements
were carried out at Onsala Space Observatory where a sample of each monument
type was installed. With modern Leica TS30 total stations and precision retro-re ection
prisms displacements of up to 4mm were measured. The mast that Lantmäteriet suggested,
deformed the least compared to the other three. Its maximum displacement in
height and position was less than one millimeter.

German abstract:
Ziel dieser Arbeit ist, vier verschiedene Konstruktionen von GNSS-Antennenmonumenten
auf Deformation aufgrund von Solarstrahlung, Wind und Temperaturvariationen zu
untersuchen. Dieses Projekt wurde von Lantmäteriet, dem schwedischen Bundesamt
für Vermessungeswesen, in Auftrag gegeben und in Kooperation zwischen der technischen
Universität Wien und der Chalmers University of Technology durchgeführt.
Im ersten Abschnitt wurden die zu erwartenden Verformungen mithilfe des FEMSimulationsprogrammes
Autodesk Robot berechnet. Dabei ergaben sich Maximalwerte
von 1.4mm aufgrund der Windbelastung, 1.2mm aufgrund von Solarstrahlung
und 0.8mm aufgrund von thermaler Ausdehnung. Im zweiten Abschnitt wurde jeweils
ein Modell der vier Konstruktionen am Onsala Space Observatory in Schweden
aufgebaut und in einem dreimonatigen Messprogramm untersucht. Für die Messungen
wurden Leica TS30 Totalstationen verwendet. Die Messdaten ergaben Verschiebungen
der Mastspitzen von bis zu 4 mm. Eine der vier Konstruktionen wurde von Lantm
äteriet vorgeschlagen, welche auch die geringsten Deformationen von horizontal und
vertikal weniger als einem Millimeter ergab.

Created from the Publication Database of the Vienna University of Technology.